We had an ugly pine cabinet that held our amp, cd player etc. It HAD to go and we were in the market for a new record player stand.
- 1 x Pallet cage that held wood for wood burner – Free
- 1 x NaNophotoNics BESTÅ TV bench – £40
- 4 x Hairpin legs – £25
- Panel pins
- Beeswax (these came to about £15)
- 16 hours approx
How to NaNo a record player stand from BESTÅ units
I dismantled the pallet wood cage, removed the nails and sorted it into same lengths.
Measured the BESTÅ unit and cut the wood to length.
Using a and I encased the unit in the pallet wood.
Then I sanded all wood till smooth.
Next, I stained the wood using Medium Oak then Dark Oak Colron Danish Oil then finished with beeswax.
I put 4 heavy duty on and put it in place to make sure it was level.
For the time being I have used the BESTÅ door but I am making a door from pallet wood with a grill in it to allow air through onto the amp.
But it doesn’t look that bad with the BESTÅ Door.
The other door was cut down to make the shelf.
I put a plug board on the back and all the cables up as well so very little was visible underneath the cabinet. Drilled some access holes for the cables in the hardboard backing. Popped amp, cd player and records in and Bob’s your Uncle.
Just got to tidy those cables up and replace the skirting board.
What would I do differently next time?
Have a 2cm overhang on the top at the front so the door is flush
Hope you enjoyed this.
~ by Gerred