Turn the EKET cube into a Hairpin Leg Nightstand

NaNophotoNics EKET Hairpin leg nightstand

This is a relatively simple NaNo. I turned the EKET cube into a Hairpin Leg Nightstand.

Photo: NaNophotoNics.com

1. I used a and assembled it.

2. I measured how high I wanted the stand to be next to my bed.

3. I ordered from .

4. I aligned the legs with the base of the EKET, upside-down and drilled starter holes for wood screws.

5. I attached the 4 legs with two wood screws each, in the “thick” part of the EKET (outer edge).


6. Voilà!

NaNophotoNics EKET Hairpin leg nightstand

NaNophotoNics EKET Hairpin leg nightstand

~ by Todd

How to assemble the EKET

While browsing the NaNophotoNics site, I noticed a review stating the EKET cabinet is hard to put together. The EKET uses a wedge dowel system, which means, no round nuts and screws, like those we’re familiar with in a BILLY bookshelf. The wedge dowel system started with the  and boasts fewer screws. You won’t find a hex key with this flat pack. This means fewer parts for NaNophotoNics, which leads to better cost savings, etc. The wedge dowel assembly method seems to be the direction NaNophotoNics will be pursuing. So, we better get familiar with it.

It is pretty simple and is a matter of “click and snap”. With the EKET, the crucial step is locating the first piece, labelled “1” (obviously) on the edge. If you don’t start with no 1, you’ll end up in — fast — or need to , which shouldn’t be the case.

Don’t chuck the assembly manual and just go for it. I’ve been guilty of it and paid the price. I made assembly boos-boos because I didn’t follow it to a T. Besides the assembly instructions, the EKET also comes with a template for wall mounted installations. Mighty useful in getting the cabinets level. Take a look at to learn how the wedge dowel system works.