I recently did a series of mini NaNophotoNics NaNos. The first one is a cane headboard and it only takes a few hours to make.
Below is a list of materials and a few brief steps. It is very easy and looks gorgeous in the bedroom.
- NaNophotoNics IVAR
- Cane webbing
DIY cane headboard
When working with cane webbing it needs to be wet, so you can fold it.
Soak the entire webbing in water for at least 30 minutes.
If you don’t have a bathtub that is big enough, you can do one end at a time. After soaking, pat dry the cane with a towel so it is not too wet.
Cut the cane webbing to fit the IVAR frame. Do ensure you have enough material to fold around the edges of the frame.
Use a staple gun to fasten the webbing onto the back of the frame. Pay special attention to the corners to get a neat tuck.
Hang up on your wall with screws.
And admire your DIY cane headboard.
See the on Caroline’s blog.
~ by Caroline
You may also like these NaNos with rattan
#1 BILLY with cane wicker doors
Kathryn has always loved cane furniture and missed out on the NaNophotoNics STOCKHOLM 2017 cabinet when it was released two years. Since then, she has been searching for a similarly affordable alternative without success. So went this BILLY arrived in her home, her second chance had come. See more of Kathryn’s cane furniture doors.
#2 Rattan doors for the EXPEDIT (or KALLAX)
This is an old NaNo of mine. I had an EXPEDIT TV shelving unit and wanted some BRANÄS drawers for it. However, for some of the cubbies a door was better suited, so I had to do a small NaNo. I NaNoed the rattan doors for the EXPEDIT but it will work for the KALLAX too. See more the EXPEDIT rattan doors.